handrail for elevated platforms

PDS #075 - County of San DiegoCounty of San Diego, Planning & Development Services. GUARDS AND handrailS. BUILDING DIVISION. 5510 OVERLAND AVE., SUITE 110, SAN DIEGO, CA 92123 (858) 565-5920 (888) 336-7553. HTTP://WWW.SDCPDS.ORG ... On the audience side of stages and raised platforms, including steps leading up to the stage and raised platforms. 3. On raised stage and platform floor areas, such as runways, ramps and side stages used for entertainment or presentations. 4.

Fall Hazards - OSHAWhen working at a height of 6' above the lower level you must use fall protection. These workers are not utilizing a personal fall arrest system. Building Structures ... Scaffolds. Scaffolds are elevated, temporary work platforms: Supported scaffold. Guardrails. Access ladders. Powered work platforms ... Stairs. Stairs that have walls on both sides must have at least one hand rail on the right-hand side when climbing down.

Part 2. Floor & Wall Openings - State of Michiganabove floor level. (2) A chute wall opening from which there is a drop of more than 4 feet shall be guarded by a barrier as specified in R 408.10231. (3) A window wall opening which is along a stairway or at a stairway landing, floor, platform, or ... Stairway railings and guards. Rule 221. (1) A stairway having 4 or more risers shall be equipped with handrails as specified in rules. 235 and 236, or a stair railing as specified in rules 233 and 236, as follows. (a) On a stairway less than 44 ...

WAC 296-24-75011: Railing, toeboards, and cover specifications.(1) You must ensure that a standard railing consists of top rail, intermediate rail, and posts, and has a vertical height of forty-two inches, plus or minus three inches, from upper surface of top rail to floor, platform, runway, or ramp level and: (a) The top rail must be smooth-surfaced throughout the length of the railing. (b) The intermediate rail must be approximately halfway between the top rail and the floor, platform, runway, or ramp. (c) The ends of the rails must not overhang the terminal ...

Five Key OSHA Standards for Work Platforms - Spika Blog30 May 2017 ... OSHA 1910.29(b)(1): The top edge height of top rails, or equivalent guardrail system members, are 42 inches (107 cm), plus or minus 3 inches (8 cm), above the walking-working surface. The top edge height may exceed 45 inches (114 cm), provided the guardrail system meets all other criteria. Spika Work Platform Mars Series. This may be the quintessential OSHA requirement for work platforms. Any work area four feet or more above the next level lower MUST have ...

The difference between IBC and OSHA stairs - ErectaStep6 Sep 2017 ... These landings should be the same width as the stairway and extend at least three feet in length. for open-sided walking surfaces like stairs and elevated platforms, handrails and guards are mandatory. And IBC-compliant stairs can't have any gaps between those handrails or guards that could allow a four-inch sphere to pass through. This is to ensure a child's head cannot pass through any section of the stairway, landing or platform. The IBC also dictates the rise ...

Compared With OSHAGuards for open-sided floors, platforms, and runways. Guards for other floor openings or platforms. Guards for wall openings, holes, and pits above floor or ground level. Open tanks or vats. Access to other elevations. Stairway slopes, treads, and risers. Alternating tread-type fixed industr

OSHA Requirements for Guardrail and Safety Railing Compliance ...1 Feb 2017 ... Determined inquiring minds can consult OSHA's revised Walking Working Surfaces ruling for general industry, but this can be a laborious process. In the interest of time, here is OSHA's official stance on guardrail for general industry applications. OSHA 1910.29(b) contains system requirements that employers must follow to ensure guardrail systems will protect workers from falling to lower levels: 1910.29(b)(1) The top edge height of top rails, or equivalent guardrail ...

OSHA Publication 3124 - Stairways and LaddersWhen splicing side rails, the resulting side rail must be equivalent in strength to a one-piece side rail made of the same material. Two or more separate ladders used to reach an elevated work area must be offset with a platform or landing between the ladders, except when portable ladders are used to gain access to fixed ladders. Ladder components must be surfaced to prevent snagging of clothing and injury from punctures or lacerations. Wood ladders must not be coated with any ...

California Code of Regulations, Title 8, Section 3210. Elevated ...(a) Buildings. Guardrails shall be provided on all open sides of unenclosed elevated work locations, such as: roof openings, open and glazed sides of landings, balconies or porches, platforms, runways, ramps, or working levels more than 30 inches above the floor, ground, or other working areas of a building as defined in Section 3207 of the General Industry Safety Orders. Where overhead clearance prohibits installation of a 42-inch guardrail, a lower rail or rails shall be installed.

Scope and definitions. - 1910.21 | Occupational Safety and Health ...Platform means a walking-working surface that is elevated above the surrounding area. Portable ladder means a ladder that can readily be moved or carried, and usually consists of side rails joined at intervals by steps, rungs, or cleats. Positioning system (work-positioning system) means a system of equipment and connectors that, when used with a body harness or body belt, allows an employee to be supported on an elevated vertical surface, such as a wall or window sill, and work ...

Handrails and Toeboards - 30 CFR 56.11002 and 57.11002 / 30 ...(e) Crossovers, elevated walkways, elevated ramps, and stairways shall be of substantial construction, provided with handrails, and maintained in good condition. Where necessary, toeboards shall be provided. (f) Crossovers shall be provided where it is necessary to cross conveyors. (g) Moving conveyors shall be crossed only at designated crossover points. There is no MSHA policy for these standards. These standards apply to travelways, platforms (coal only), crossovers, elevated ...

Clearing Up the Confusion Surrounding Fall Protection | EHS Today1 May 2010 ... Fall protection systems (e.g., guardrails for platforms and railings for stairs) are addressed, but personal fall arrest equipment, such as lanyards and harnesses, are not. Housekeeping High traffic areas should be kept free from tools, materials, debris or spilled or leaked liquids. These types of items can contribute to slips and trips on the same level. OSHA requires employers, in 1910.22(a), to keep their facilities clean, orderly and as dry as possible. for work on a ...

Subpart D Walking-Working Surfaces - OSHAExamples of personal fall protection systems include personal fall arrest systems, positioning systems, and travel restraint systems. Platform means a walking-working surface that is elevated above the surrounding area. Portable ladder means a ladder that can readily be moved or carried, and usually consists of side rails joined at intervals by steps, rungs, or cleats. Positioning system (work-positioning system) means a system of equipment and connectors that, when used with a body ...

Floors, stairways, railing, overhead protection and ... - Ohio BWC(7) "Runway" means a passageway for employees, elevated above surrounding floor or ground level. (8) "Stair platform" means an extended step or landing breaking a continuous run of stairs. (9) "Stair railing" means a vertical barrier erected along exposed sides of a stairway. (10) "Stairs (stairway)" means a series of steps and landings having four or more risers leading from one level or floor to another, or leading to platforms. (11) "Standard guard railing" means a substantial barrier, ...

Product Details

Product List